Lecture 203 – Introduction to 3D Rhinoceros (Fall 2016)

Lecture 203 – Introduction to 3D Rhinoceros (Fall 2016)

An overview of basic 3D drawing techniques in Rhinoceros including the rotate3d, extrudecrv, & project commands source
Lecture 225 – Introduction to Sections (Fall 2018)

Lecture 225 – Introduction to Sections (Fall 2018)

An overview of sectional renderings in Rhino and V-Ray. Includes how to use the SectionTools plugin to establish a sectional view and how...
Lecture 228 – 2D Drawings from Rhino – Elevations (Spring 2016)

Lecture 228 – 2D Drawings from Rhino – Elevations (Spring 2016)

An overview of how to make a line drawing elevation from a Rhino 3D model using the make2d command. Includes how to do...
Lecture 228 – 2D Drawings from Rhino – Elevations (Fall 2017)

Lecture 228 – 2D Drawings from Rhino – Elevations (Fall 2017)

An overview of how to make a line drawing elevation from a Rhino 3D model using the make2d command. Includes how to do...
Lecture 205 – Modeling Components (Part 1) (Fall 2016)

Lecture 205 – Modeling Components (Part 1) (Fall 2016)

An overview of modeling a component including chamfering surfaces, and lofting curves. Includes basic rendering of resulting component in V-Ray after assigning a concrete...
Lecture 226 – 2D Drawings from Rhino – Elevations (Fall 2018)

Lecture 226 – 2D Drawings from Rhino – Elevations (Fall 2018)

An overview of how to make a line drawing elevation from a Rhino 3D model using the make2d command. Includes how to do...
Lecture 229 – 2D Drawings from Rhino – Plans (Spring 2016)

Lecture 229 – 2D Drawings from Rhino – Plans (Spring 2016)

An overview of how to make a line drawing plan from a Rhino 3D model using the make2d command. Includes how to do...
Lecture 229 – 2D Drawings from Rhino – Plans (Fall 2017)

Lecture 229 – 2D Drawings from Rhino – Plans (Fall 2017)

An overview of how to make a line drawing plan from a Rhino 3D model using the make2d command. Includes how to do...
Lecture 206 – Modeling Components (Part 2) (Fall 2016)

Lecture 206 – Modeling Components (Part 2) (Fall 2016)

An overview of modeling a component including using sweeps. Includes discussion of sweeping with both 1 and 2 rails as well as using...
Lecture 227 – 2D Drawings from Rhino – Plans (Fall 2018)

Lecture 227 – 2D Drawings from Rhino – Plans (Fall 2018)

An overview of how to make a line drawing plan from a Rhino 3D model using the make2d command. Includes how to do...